Our products allow to deliver excellence at the highest possible level of operational efficiency. The range of products have been specifically engineered so that they can be applied by dipping, flow coating, brushing, swabbing and spraying.
Coatings for Sand Moulds and Cores
The high casting temperatures associated with steel foundries requires careful selection of refractory materials, to ensure full protection against metal penetration and burn-on defects.
The range of coatings utilise high purity zirconium silicate or metal oxide refractories to offer protection under the most extreme casting conditions.
A full range of specialist products is also available to cover specific applications, such as the high demands of manganese steel, highly alloyed stainless steels or metal penetration due to hot spots or high metallostatic pressures.
Intelligent Coating Unit
The ICU (Intelligent Coating Unit) automates the coating preparation from its as supplied state to the density that delivers the most consistent layer thickness – continuous monitoring, control and adjustment ensures optimized coating performance utilization. The ICU is ready for Industry 4.0 standards.
Flow coating equipment
The equipment consists of three main parts: the pressure tank, the control box and the catchment tray. It operates on the principle of displacement of the coating from the tank via a flexible hose by use of low pressure compressed air.
No other power source is required and the low degree of wear due to the absence of mechanically moving parts in contact with the coating is of special advantage.
Want to know more?
Head office - Sydney - (02) 99145500
Melbourne - (03) 97924033
Brisbane - (07) 3917 1801
Adelaide - (08) 83472622
Perth - (08) 93506099
New Zealand - +64 9 274 4559
Fax: +61 2 9914 5547
General enquiries can be directed here