FDU rotary degassing equipment
FDU degassing units are an automated metal treatment system for the environmentally-friendly degassing and cleaning of aluminium and copper alloys.
FDU units use the impeller principle with a patented rotor which creates fine inert gas bubbles and mixes them with the melt. These fine bubbles are distributed homogenously throughout the melt without disturbing the surface maximising the contact area between the gas and the melt. The effectiveness of the Foseco FDU means that higher levels of degassing and cleaning can be achieved and treatment times can be reduced.
Metal Treatment Station (MTS) one-step automated treatment system
By using the MTS System (Metal Treatment Station) aluminium melts can be completely and automatically treated in one step. Whilst degassing with the proven FDU technology, all required treatment agents can be added at pre-set levels.
FDU XSR graphite rotor
The XSR rotor type can be used in combination with all Foseco graphite shafts. Turbo cuts in the upper section of the rotor further reduce the size of the inert gas bubbles thus maximising the surface area of the bubbles for a given volume of treatment gas, resulting in fast and consistent hydrogen removal. XSR rotors are supplied in the impregnated condition to reduce oxidisation and extend service life.
Additives, Fluxes and Coagulants for Non Ferrous Alloys
Foseco offers a broad range of chemical products for the treatment and refinement of aluminium and other non ferrous alloys including:
- Fluxes for Drossing, Covering and Cleaning Aluminium Alloys
- Grain Refiners for Aluminium Alloys
- Modifiers for Aluminium Alloys
- Fluxes for cleaning, remelting and element removal of copper base alloys
|Recommended Products||Aluminium||Copper base|
COVERAL GR 2512
COVERAL MTS 1565
|Drossing||COVERAL GR 2531||SLAX 20|
NUCLEANT 70 SS
COVERAL MTS 1582